GeneRally International Forum

Hi all,
something no one expected (I even surprised myself), punctual just after the first race has been held, I'm proud to present you my Formula 1 2013 carpack.
The pack includes 11 models which are all unique (apart from Mercedes - McLaren, they share the same model ), but with equal physics. The physics were taken from the PGRF1 2011 carpack. As I had and have several problems applying my physics to F1 cars (which was really notificable in the 2011 pack, but would still be imperfect with my current physics), I asked Rudy and he gave me the permission to slightly modify the physics.

So here they are, fresh from my car factory I hope you enjoy them, so please leave a comment.

Just a couple of points I see from the screenshot. It's probably just the angle but the front of the Ferrari looks really odd and cut off. Also the shadow at the front, I think would have been better had it led to a single point, rather than this 'squared' end.

As I said, this is going by the screenshot, so may look completely different when actually being used, Otherwise I really like the models!

Thanks for your comment, BBA I made the nose of the Ferrari like this to have 2 more vertices left. As a result, there are those white stripes below the air intake leading to the front. Of course I can understand that not everyone likes it that much cut off, but I think it's the best solution for this car (at high WS, where F1's are often used, you don't really notice the little kink in the hood ). If it would only bother you that the nose is so short, I looked on a photo and there it was significantly shorter than the front wing.

Talking about the shadows, I don't really like a "single point" solution. However it might be an idea to move the squared end "under" the front wing, so that it becomes invisible...

Some more comments please?

These are very good Formula 1!!! At physical I do I can't well! I have the model, but I can't do the physical.